Measurement-specialties PCI-DIO24 Manual do Utilizador descarregar pdf (Página 14)

PCI-DIO24 User's Guide Functional Details

When installed, the SIP establishes either a high or low logic level at each of the eight I/O lines on the port. At

each board location, A, B, and C, there are 10 holes in a line. The hole on one end is marked "HI" and is

connected to +5V. The other end is marked "LO" and is connected to GND. The eight holes in the middle

connect to eight lines of the port, A, B or C.

To pull-up lines, orient the SIP with the common pin (dot) toward the HI end; to pull-down, install the resistor

with the common pin in the LO hole.

Note:

We recommend using 2.2K SIPs (MCC part number SP-K2.29C). Use a different value only if necessary.

1 2 ... 9 10 11 12 13 14 15 16 17 18

Sem comentários

Measurement-specialties PCI-DIO24 Manual do Utilizador Página 14